neone know i recently bought a obx header and dont know the torque specs
Printable View
neone know i recently bought a obx header and dont know the torque specs
IDK the tq specs but i know i just do it pretty tight but not over kill. Dont gorilla kill the bolts. Just remember to go from the middle out and tighten little by litte. I.E. tigthen 1/4 way from the center out then go back and tighten again and keep doing that till you feel as if its good enough. Someone may say differently but thats how i do mine.
Wrong area This should be in 8G customizing the car.
If you cant finger it out use the two torque method use a regular socket wrench and tighten til your 2 veins pop out. Thats how we tightened everything at the shop when we re assembled unless we used an air ratchet
Service manual says for SOHC exhaust manifold nut requires 13lbs of torque. I suggest also to apply some high temp nickle anti seize on the nuts before you torque them down.
BTW: moving to proper section.