does anyone have h i d i and how did you make the whole on the headlight cover
Printable View
does anyone have h i d i and how did you make the whole on the headlight cover
You need to explain a little more I dont understand what you want.
yes i have HID's
there is a cover for the 7 g that cover where you get to the light bulb but when you get hid how do you put it back
well I have an 8g and it comes with a rubber cover with oem bulbs, with HID's i didn't put it back but you can always try cutting it to fit.
I understand what you are asking.Quote:
Originally Posted by warren
The 7g has a weatherproof cover for the access to the low beam(and a seperate one for the high beam)
the wiring to the bulbs goes through a harness that enters the headlamps from a different spot.
So to access and change bulbs, you have to remove these access covers... which do not have holes.
In order to install HID's you have to drill holes through the access covers for the HID wiring.
I do not have ths problem because I have different headlamps. However some other 7g guys may e able to help you.
your kit should of came with rubber seals. you drill holes in the white caps (weather proof seals) install the seals in the newly drilled holes, and then run the wires through the hole
yeah that i did today
wtf
pointless?Quote:
Originally Posted by Randolph
sorry
I left mine open...simply because the headlights I have are shitty to begin with. When I get my JDMS I am gonna run the wire properly so the light is sealed. The only way to close the back is like they said drill a hole, or pull the light out and run the wiring in the same place as the OEM wires
jdms you dont need to. the rear housing is diffrent ;)Quote:
Originally Posted by evil-G-nius