Yup... should be ok
Sent from my Z796C using Tapatalk
Printable View
Yup... should be ok
Sent from my Z796C using Tapatalk
All in the prep work too.
So what just use some stuff to strip the paint off (can't think of the name off my head) and spray over it? Any reason to sand or anything
Sent from my iPhone using Tapatalk
Clean then real well. Preferably use purple power and power wash them. I'd strip then with aircraft paint remover and rinse then after preferable power wash them to ensure everything is gone. Scuff them with 320 grit and sprain them per the cans direction.
Others may have different methods but that's how I would do it.
Sent from my Galaxy S4
Ight, I'd heard that before too so that's prolly what I will do
I've got a couple 5gal jugs of some paint remover stuff in the garage I'll use (just cuz I don't wanna go buy anything) XD
Sent from my iPhone using Tapatalk
Careful with the seals and that air craft paint stuff, don't want to resale if you don't want to.
yeah I will apply whatever I got by hand using an old rag/shirt/etc and clean it up that way, same stuff I used on my valve cover
Nice brakes you got there Demon, whats a set going for?
Front coils are on.. end links are a Different story, driver side nut wont come off :076: and i don't own any impact tools so paying a few $$ tomorrow for a tire shop to get it off.
http://i1273.photobucket.com/albums/...pscd9c5572.jpg
Did you try to spray some Blaster PB?
I can never get my impact back there anyway. I've always just taken a cutoff wheel to the stud.
I got those to my door for just under $500...not bad considering a set is around $600 on eBay
And these had pads with em
Sent from my iPhone using Tapatalk
I scored a set for $250 from a kid on Craigslist. And another sets I sourced the fronts and rear separately and ended up around $275. Deals like that don't come around often.
Sent from my Galaxy S4
^ haha loving it!!
Today was gold mind junk yard day. Grabbed me a set of brand new headlight assemblies not a single scratch or ding or a sign of yellowing at all 15$ each, and a 6g72 tb that I'll need to deep scrub.
x2 ^
Sent from my iPhone using Tapatalk
Umm yeah they needed to go....
http://i1273.photobucket.com/albums/...ps39dc5dd7.jpg
Before
http://i1273.photobucket.com/albums/...ps0b87dd68.jpg
After
http://i1273.photobucket.com/albums/...psdc3f77db.jpg
Going lower after i replace the tie rod's and get a energy suspension kit for the rest of the bushings.