This weekend I did a little fiberglassing. Just waiting for the other two gauges
http://i739.photobucket.com/albums/x...5/IMAG0355.jpg
Printable View
This weekend I did a little fiberglassing. Just waiting for the other two gauges
http://i739.photobucket.com/albums/x...5/IMAG0355.jpg
Looks good, nice work!
Nice
Very nice
Thanks guys, I think I'm going to wrap it in the DiNoc stuff... Hey gotta question, for the oil feed line, if you put a t off of the oil pressure sender, is it enough volume of oil for the turbo itself? Just wanna make sure
sandwich adapter meaning you drop the oil pan and bolt an adapter to that and run almost like an oem turbo feed?
No.
Sandwich adaptor is a ring that mounts between the oil filter and filter housing that will have a few ports for which to source pressurized oil. You can use the ports for oil pressure sensors or for turbo feed lines. No need to remove the pan.
something like this...
http://cgi.ebay.com/ebaymotors/Gredd...s#ht_500wt_956
OK I was thinking about going that route anyways, I just need to find the fittings, but I still gotta drop the oil pan to install the drain tube, might replace it with a new one. Also Ive been searching around on here for the wiring on the 74 TB for the IAC, I cannot find it anywhere on here, but I think I'm over looking stuff, any ideas?
does anybody have a pinout for the galant? I looked around here, found a link in G Torque's thread but its dead...
Hey just to make sure I get the right tb gasket for the 74 to outlander manifold, will every hole line up?
Very nice progress! Keep it up! Car's looking good!
I posted up the automatic ECU to 5-speed EVO ECU conversion chart in his thread, its gone? Im not sure if the 02 is different pinout, the one I posted was from a 00' from Napalm on C3g.
http://i3.photobucket.com/albums/y83...de/pinout1.jpg
http://i3.photobucket.com/albums/y83...de/pinout2.jpg
Thanks man its slowly going, so sad its going to be put on hold for 8ish months though...
Nope I have that one Stewi, I'm looking for the Galant pinout, like pin 1 is where on what connector... QNZ had one, thats the link thats dead
I know I posted that up already too. Not sure which thread it was in, I know it was a project thread though....
bang!!!!
Couldn't find mine, but I found the one Aaron posted...
http://i203.photobucket.com/albums/a...stuff/ecu1.jpg
sweet! now as the evo ecu pin out is, this is read from the ecu correct?
yeah this is if you were staring into the end of the ECU.
Yeah.. Idk why I asked that... but I got it finished.. done for the night, but I'm going to meter everything make sure there is no shorts, and to make sure the pins are connected to the correct corresponding pin haha
http://i739.photobucket.com/albums/x...5/IMAG0359.jpg
Also got me gauges and my 4 inch to 3 inch silicone reducer haha... so now I can use the spectra maf adapter.
http://i739.photobucket.com/albums/x...5/IMAG0360.jpg
Finally... looky looky what came in today :) for those who have done the swap with a 74 TB, how did you wire it up?
http://i739.photobucket.com/albums/x...5/IMAG0361.jpg
anybody know the part number for a 6g74 TB gasket? I cannot find it on here at all