Eclipse exhaust

**bmxmike** · 01-25-2008, 11:40 PM

I know that the Eclipse exhaust will fit the 7g galant but does it have to be off the turbo models or will the non turbo one work? Like the rs and gs? I know that you have to extended it some cause the galant is longer than the eclipse just wasn't sure if version mattered

**laxinwarrior** · 01-26-2008, 12:47 AM

I'm pretty sure as long as it's a cat back system, it will work. I believe the only difference is the routing of the exhaust manifold from the 420a to the cat. You might want to have someone else verify it though.

**kolio** · 01-26-2008, 01:27 AM

i think the cat's are diffrent for the 420a

just to be safe get one for a gst

**mko** · 01-26-2008, 01:39 AM

All RS, GS and GSt have the same cat-backs. Dont know for the GSX. I got mine of GSt

**laxinwarrior** · 01-26-2008, 01:43 AM

GSX is different and will not fit the Galant.

**mko** · 01-26-2008, 01:49 AM

Yeah, I think that GSX's exhaust doesnt have the loop over the rear cross-chamber and goes under it.

**kolio** · 01-26-2008, 02:31 AM

Originally Posted by mko

Yeah, I think that GSX's exhaust doesnt have the loop over the rear cross-chamber and goes under it.

yes sir

**bmxmike** · 01-26-2008, 11:37 AM

So everything except the gsx wont fit? Just checkin cause my friend has a megan exhaust off a rs that he was going to just give me its a cat back

**seth98esT** · 01-26-2008, 11:39 AM

Originally Posted by bmxmike

So everything except the gsx will fit? Just checkin cause my friend has a megan exhaust off a rs that he was going to just give me its a cat back

^Fixed your post. Everything except the gsx WILL fit, but will need extended. Not a hard job to do for any exhaust shop, wouldnt think they would charge more then $75 at most.

**kolio** · 01-26-2008, 12:22 PM

angel when he had his 7G didn't even extend it, it just sat 3-4 inches in from the edge of the bumper

**Sleepervr-4** · 01-26-2008, 12:29 PM

Originally Posted by kolio

angel when he had his 7G didn't even extend it, it just sat 3-4 inches in from the edge of the bumper

I did extend it about 6" so it could bolt on to the stock cat. If I would have extended it in the rear it would have been perfect. It is about 4 inches short in the rear and 6 inches short in the front where it bolts on to the cat. All hangers work but the very last one by the tailpipe. You have to unbolt the last hanger and have it welded in a vertical angle instead of how it sits stock (horizontal). Btw I used the Greddy SP for the 2g gst. Maybe jay can post pics of it since he still has the car.