Big problem

[warren]

This is what happen when i started the car the motor idle at 2,000 rpm let it warm-up for 10 minutes. I plugged the computer and look at the data stream every work fine but when i just pressed the gas a little bit then fan turn on the fuel cause to zero everything but the car work. WHAT CAN BE THE PROBLEM PLEASE HELP
Here is the video of what wrong http://www.youtube.com/watch?v=z7Rj62dJiuw

[Reelax]

wait what?

[koji464]

obd2 scanner... or your plugged in to the ecu by some other means......??
couldnt realy read that post..

[Reelax]

obd2 scanner... or your plugged in to the ecu by some other means......??
couldnt realy read that post..

i couldn't even start to guess.

[warren]

yes in the obd 2 it was connected in there

[Reelax]

still have no idea what you are asking.

[warren]

ok when i turned on my car my car idle at 2,000 rpm i let it warnup still at 2,000 rpm so i plugged in the obd 2 computer put it on data stream i checked everthing working fine but when i pressed the gas fan turn on go on 1,000 rpm

[koji464]

if its not throwing any codes, then your good to go..
btw you should adjust your idle, cause you shouldnt be sitting at 2k after the car has been warmed up lol

[warren]

ok when i pressed the gas it idle down the fan turn on

[skrap]

Yes but you should be idling at around 800rpms.... And then when your fan kicks on its should drop down to about 6... You should not be idling at 1k with your fan on....

[Shadow19]

check our coolant temp switch.

[warren]

i changes it