It's pretty straight forward if you buy a good kit from a reputable manufacturer. I recommend AlkaPlus. That's where I got mine.
1) Remove each piece of trim that the overlay is going to be placed on.
2) Clean each one thoroughly with some 91% isopropyl alcohol
3) Apply the activator (suppied with the kit) to the piece you're covering. Apply sparingly...this stuff is like instant cement
4) Peel the backing from the trim piece and apply it to the dash piece. press gently but make sure it covers and is aligned properly.
5) Replace the trim piece in your dash
The kit will come with directions and pictures. The one thing to be careful of is once you apply the activator and begin to put the trim piece on, make sure it's aligned correctly, as it will be near impossible to move it once the activator touches the 3M tape. Take your time and be precise and you'll wind up with a good looking kit.
Bookmarks