LEDs in gauge cluster.

[DOHCstunr]

you can also do the ignition ring and the glove box of course. I put a green 3 smt 74 in the igntion ring. Looks sweet. I bought 2 pairs of the green 74's and put two greens in for the turn signal indicators, and had one spare. Sooner or later I might get some red ones for the CEL, brake light, door ajar, and a pair of amber ones for the ABS light and the low fuel. But seems like a waste of dough. I'll probably get to that down the road when I'm bored and don't have enough cash for anything major.

[evil-G-nius]

Hmm....blue for the ignition ring would look bad ass

[Fresh_617]

you can also do the ignition ring and the glove box of course. I put a green 3 smt 74 in the igntion ring. Looks sweet. I bought 2 pairs of the green 74's and put two greens in for the turn signal indicators, and had one spare. Sooner or later I might get some red ones for the CEL, brake light, door ajar, and a pair of amber ones for the ABS light and the low fuel. But seems like a waste of dough. I'll probably get to that down the road when I'm bored and don't have enough cash for anything major.

Do you have any pics of that?

[98mgalant]

I don't know anything about 8g.

[Joker96]

i think i broke the gas thing. i think its not measuring correctly anymore i just removed it and when put back now says a diff thing

[Da_Prodigy]

Just top off gas tank and insert the the needle on the Full line just dont press it down too much or it won't move.

[Joker96]

does the needle have a max and minimum? i mean so it wont go all the way around? i dont know f u understand what i mean

[Da_Prodigy]

What I'm saying take your car to the gas station fill it completely with gas, once it's completely filled, take off the needle and just re-insert the needle at the full line. Just make sure not to press down all thr way because if you press the needle all the waydown it sometimes gets stuck. There is a max and minimum mark but if you don't align the needle right in the beginning it's obviously going to be off.

[Joker96]

got it, thanks

[raks_22]

can i use t10 ones?

[98mgalant]

I'd say stick with the 94 and 74s but you should try and buy then from the same place and make sure to get the same colors.

[raks_22]

gonna try it, i have another cluster in the mechanic place

[raks_22]

no?

[98mgalant]

Did it not work?

[raks_22]

i dont know, im asking for the T10 SMD leds.

[98mgalant]

The ones that will work are the 94 and 74 LEDs. I don't know about those.

[raks_22]

i dont know where to buy them :S ebay isnt an option to me, haha gonna be more expensive the shipping than the leds haha

[Galanttuner10]

nice. im going to do this on my new GS cluster. on a side note can we make the thing go back to 000000 as if i could id like to do that.

[neoechun]

will this type of smd works?

[98mgalant]

Not as well as the ones that have three of the LEDs on them. but just as far as them fitting and lighting up ya.