what would be the best way to get this off?????
what are you trying to get off??? the harmonic balancer is held on there with 4 bolts and should slide out with no problem...if not get a rubber mallet and hit it a few times...if you want to remove the center bolt, an impact gun will do the job...with that breaker bar all your doing is turning the crank.
Fully Built 4G63
HKS 272
ported Dual Ball Bearing FP RED 84mm 25psi w/ external dump
you if you want the pulley 4 bolts and a pulley puller if its stubborn. center bolt needs power tools
2014 Lancer Evo GSR
1996 Galant S 5 Speed Turbo
Need a Turbo rebuilt or upgraded--> http://www.thegalantcenter.org/showt...ebuild-Service
If you are taking the crankshaft bolt off then you can use a screwdriver, just wedge it in one of the teeth of the flywheel. I had to do that when I replaced my balance shaft belt.
Posting Rules
Log in
Register
Reply With Quote
Bookmarks