Wrapping all dash in carbon

[Jenkis]

So i Decided to wrap interior whole interior.. Im gonna use 3M Carbon Vynil. the most important question is: how hard to take out Front Panel or Front dash I dunno how to call it. It's allright with doors but front panel..

[IVORY_G]

Taking out the dash is alot of work, but not too complicated. Just set aside enough time to do it and dont rush through it...

[FX2236]

I was thinking the same , Would love to see the end results .

[Jenkis]

Dont worry whenever I'll start this project I will keep you guys up to date with photos and problems aswell :) first things first... need to take some holidays from work. and arrange everything.

[twisted_galant]

I wrapped the pieces of my under dash in carbon wrap, as well as my door panels. Really just because it compliments the paint on my fiberglass dash. Check it out here.
https://www.thegalantcenter.org/showthread.php?t=44946

[2002BlackDragon]

Hey twisted, is that real CF or is that the 3M Carbon Vynil that is more like a "sticker"? And how difficult was it to work with?

[bobmundo123]

Hey twisted, is that real CF or is that the 3M Carbon Vynil that is more like a "sticker"? And how difficult was it to work with?

wellll....

So i Decided to wrap interior whole interior.. Im gonna use 3M Carbon Vynil. the most important question is: how hard to take out Front Panel or Front dash I dunno how to call it. It's allright with doors but front panel..

anddd..

Doesn't look toobad.. heat gun is a must..

[2002BlackDragon]

Awsome vid! I think i know of a future project......

[twisted_galant]

Hey twisted, is that real CF or is that the 3M Carbon Vynil that is more like a "sticker"? And how difficult was it to work with?

Its the vinyl sticker... It is not to bad to work with but definately takes some patience and some trial and error. A heat gun is a must if you have any tight angles/bends/turns/curves.