turn lights question

[master_visionary]

Yup that's what I figured now to get you those harnesses

[Copia]

aight guys thanks a lot im starting to understand this lol

what i need to get is this sockets?
http://www.ebay.com/itm/1157-T25-101...item336f9a10e1

and get a 1157 bulbs? all i found on ebay was only led bulbs
http://www.ebay.com/itm/2pc-1157-Bay...item3cbf4ec36a

and all things that i gotta do is just rewire them and it will work?
btw i need some help with wiring the new sockets to my JDM galant cuz i dont know
how to rewire it...

btw, my parking lights in JDM is sitting under the low beam lights, so what should i do?
cancel those lights and connect them to the new sockets or what?

[oakrdrs187]

If you dont want it there and just run it over to where the turning light is when you get the project going. But if you want ti there just leave it and tap into it when you begin this.

[Copia]

aight so just to expose part of the parking lights cable and connect it to the low part
and the turn lights cable to the high part? that's all i should do ? and what about rewiring the
1157 sockets to my JDM galant? how can i do that?

[master_visionary]

Check out the link

The metal body is the ground tap into a black wire
The two circles on the bottom are the positive leads for each filament
Tap the low beam to the low filament
Tap the signal to the high

The link explains this in great detail but so it makes sense

Email me if you want me to just send you usdm harnesses

[master_visionary]

I got the turn signals. Lights and wires if you interested Copia. Hold for pics I got you the bulbs sockets and wires ....the wires are extra short on one just pay postage and hit up my trade rating hi can have them the bulbs are new and I will extend and label the wires for you if you likr

[master_visionary]