Activity Stream

I think it all depends on your aftermarket ignition system your going for. You might want to reach out to Microsquirt to see what they require to...

Thanks for the quick replteply and help. Yeah I went with a rock auto closeout sensor..first rock auto ordered part to give me an issue..I even put...

So, i can only use the CAS sensor? no need for the crank trigger wheel? i think hondas 92-04 dont have a crank sensor, just a cam angle sensor. My...

Return the sensor and get a different brand. Did you replace it with an oem sensor? If it doesnt thread in or clip in then there something off. Check...

Oh yea I totally forgot about cam angle sensor. If your head doesnt have a housing for the CAS then your stuck with the crank trigger wheel. If...

Yes i need everithing you just said. im thinking about using a megasquirt1-2 or a micro. Thats why i want to buy the intake with all the things u...

you would need ALOT of parts to swap over to stock efi system. ECU, entire ignition system, fuel rail, injectors, intake manifold, throttle body, maf...

Nice! Welcome!

Bryant, u need to go to canada and get a legnum

Thanks! No, this is actually the only Legnum I've seen in person. There are a few more out west I hear.

Congrats on the purchase, looks nice with those Enkies. Are they alot of those floating around in Canada?

If anyone still read this forum, rear seat from xg300/350 does NOT fit. Bottom clips are 1 inch wider on xg and got different shape. Top (even...

If anyone still read this forum, rear seat from xg300/350 does NOT fit. Bottom clips are 1 inch wider on xg and got different shape. Top (even...

Hmmm I have an exedy clutch in the garage. I have to look. I don't recall the discoloring being this vivid. Sent from my LM-G710 using Tapatalk

I think the discoloration is factory heat treating. From what I can tell, the spring broke out of the carrier and became wedged behind the pressure...

You got it right on the money!

I do like that too a lot. So far could add a rear sway bar if you just swap the lower rear control arms off the eclipse to theGalant. And could swap...

Wow that got hot! Wonder what happened there. Also did you install your TOB clip? Sent from my LM-G710 using Tapatalk

No more guessing is needed. Pulled the trans today. Found the issue. Installed the new clutch, pressure plate, and throw out bearing. Reinstalled the...

Yea I was gonna mention the throw out bearing but usually it makes a whining sound when they start to go.

I love how most parts cross over so easily on these cars

April 6th 2019 Removed the Rear Shock assemblies and the rear sway bar with the lower control arm and swapped it to the Galant. One control arm...

I don't really drive it hard. I'm not sure that it could be something internal. I believe the clutch isn't fully disengaging. I've already done the...

Pics?

That sucks, I hate reinstalling that trans. I hate it so much I just pull the motor out. When you drain the gear oil you screen it and look for any ...