StreetDreams
02-26-2005, 02:59 PM
THESE INSTRUCTIONS ARE SPECIFIC FOR A 95 GALANT AND A FIRST GENERATION SAFC.
I believe the 94-96 Galant have the same ecu and wiring, but the 97-98 would be different. Also, the SAFC II may get wired differently and may have different color wires.
These instructions are to be used at your own risk; I will not be held responsible for any problems or damages that result from following this tutorial.
I am leaving out the obvious steps. I am assuming that you know how to get to the ecu and that you can handle some simple wiring. If you don't know either of those things, please do not attempt to install the SAFC yourself.
Disconnect battery!!!
Wire connections:
POWER------------------------------red wire from SAFC======Pin 25; red wire at ecu
RPM SIGNAL-----------------------green wire from SAFC=====Pin 69; brown wire w/ green stripe at ecu
THROTTLE SIGNAL----------------gray wire from SAFC======Pin 64; green wire w/ white stripe at ecu
GROUND----------------------------brown wire from SAFC ====Pin 26; black wire at ecu
GROUND----------------------------black wire from SAFC =====Pin 26; black wire at ecu
The brown wire from the SAFC needs to be tapped closer to the ecu than the black wire from the SAFC!!!
AIR FLOW SIGNAL OUT-----------pink wire from SAFC======Pin 70; white wire w/ black stripe at ecu
AIR FLOW SIGNAL IN-------------orange wire from SAFC ====Pin 70; white wire w/ black stripe at ecu
The air flow signal wire (pin 70, white wire w/ black stripe) gets cut. The pink wire taps into that wire on the ecu side and the orange wire taps into that wire on the harness side!!!
ECU diagram
Make sure that you are looking at the diagram the correct side up; if looking at the ecu in the mounted position the push tabs are on the bottom. The plugs' push tabs are pictured on the top of the diagram so you would need to turn it upside down for proper orientation.
http://img.photobucket.com/albums/v654/majeztic/scan.jpg
Reconnect battery
SET SAFC TO KARMEN TYPE SENSOR!!!
If I left out anything important or if any one has anything to add, feel free to post.
Hope this helps!!!
I believe the 94-96 Galant have the same ecu and wiring, but the 97-98 would be different. Also, the SAFC II may get wired differently and may have different color wires.
These instructions are to be used at your own risk; I will not be held responsible for any problems or damages that result from following this tutorial.
I am leaving out the obvious steps. I am assuming that you know how to get to the ecu and that you can handle some simple wiring. If you don't know either of those things, please do not attempt to install the SAFC yourself.
Disconnect battery!!!
Wire connections:
POWER------------------------------red wire from SAFC======Pin 25; red wire at ecu
RPM SIGNAL-----------------------green wire from SAFC=====Pin 69; brown wire w/ green stripe at ecu
THROTTLE SIGNAL----------------gray wire from SAFC======Pin 64; green wire w/ white stripe at ecu
GROUND----------------------------brown wire from SAFC ====Pin 26; black wire at ecu
GROUND----------------------------black wire from SAFC =====Pin 26; black wire at ecu
The brown wire from the SAFC needs to be tapped closer to the ecu than the black wire from the SAFC!!!
AIR FLOW SIGNAL OUT-----------pink wire from SAFC======Pin 70; white wire w/ black stripe at ecu
AIR FLOW SIGNAL IN-------------orange wire from SAFC ====Pin 70; white wire w/ black stripe at ecu
The air flow signal wire (pin 70, white wire w/ black stripe) gets cut. The pink wire taps into that wire on the ecu side and the orange wire taps into that wire on the harness side!!!
ECU diagram
Make sure that you are looking at the diagram the correct side up; if looking at the ecu in the mounted position the push tabs are on the bottom. The plugs' push tabs are pictured on the top of the diagram so you would need to turn it upside down for proper orientation.
http://img.photobucket.com/albums/v654/majeztic/scan.jpg
Reconnect battery
SET SAFC TO KARMEN TYPE SENSOR!!!
If I left out anything important or if any one has anything to add, feel free to post.
Hope this helps!!!