Oil Filter Block Adapter

[98TintedGalant]

Hey quick question,
has anyone had any experience with these? I've searched around here and noticed it when it was written in the oil pressure gauge install. The one I was looking at is the example below, It seems like it would need atleast one gasket to seal.

http://cgi.ebay.com/ebaymotors/Oil-Filter-Block-Adapter-OIL-TEMP-OIL-PRESSURE-GAUGE_W0QQcmdZViewItemQQcategoryZ6763QQihZ009QQite mZ190083960989QQrdZ1

Have you guys had any luck with anything like this?

Thanks

[DOHCstunr]

i used to use one for my oil pressure and il temperature gauges.
they are easy to install and do the job.

i still have it. its anodized blue.
if you'd like one, i'll sell it to you.
i'll let it go for 30 shipped.
since you are new, it woudl have tot be paypal.
send me a private message if you are interested.

[98TintedGalant]

Thanks but the only problem is, the only gauges around here are all mech. I could pick one off ebay. but everything has to fall into place. Ill defanitly keep you in mind, thanks.

[98TintedGalant]

Another Quick question. If I were to do an A/F gauge instead of Oil, could I just hook up to the wire coming into the ECU, or would it have to be the O2 sensor like I've been reading.

If I could do the ECU, is it the black wire with a white stripe?

Thanks

[98TintedGalant]

Also after searching you can use the Pre Cat 02 sensor. Trouble is I see almost three white wires, or 1 light grey and 2 white wires, which one should I use? And also can I just a connector that just splices that you can just clamp on the wire?

Thanks for all your help agian.

Dan