New Problem

[duh2150]

alright i got everything hooked up and im trying to crank the engine but all it does is buzz i shorted out pin 9 and 10 and nothing.. anything else do i gotta do with the connectors? or somthing? help please thanks

[pinoyesv6]

wehat were you doing?? where is the buzz coming from?

[duh2150]

sorry im doing a tranny swap and i donno where the buzzing is comming from i think its near the firewall but it wont start up and i shorted out 9+ 10 but still nothing

[pinoyesv6]

the buzzing is like a mechanical buzzing or is it an electrical buzzing?

[duh2150]

im guessing its electical becasue it wont crank liek tis suposed to

[pinoyesv6]

depending on the buzz i'd look at one of two things.

the battery cables. make sure they are not only clean but on tight. on the battery and further down the cable since you might loosened it somewhere else.

or i'd shoot at the fuses and the fusible links to make sure they are all good.

[Jet Black]

Is your alternator properly connected?

[fatal1]

did you install the new starter correctlly? make sure all the wiring was put back in order?, did you make sure you didnt clamp any wires and they may have broke or something, you did just modify a lot of things so it can be a wide variety of stuff, but try to start out with the simple things like the battery first, did you try to jump it or juice it up see if you had any crank at all?

[duh2150]

yeah i cleaned the cables on the bttery and ground and stuff and i just charged the battery to 100% and im gonna try that when i get form school

[duh2150]

but we did hook it up on the charger for a bit and it just buzzed still my dad says it does that when theres a lose connection or somthing but i dont think so, with the harnesses lie kthe gray one do i just wrap it up and put it someplace? and pin 9 and 10 are the 2 big ones t othe right, right bottom right

[GOOSEY2099]

wait wait wait, you can't just through this out lie "I have a buzzing" Tell me Exactly what you installed in this swap. Everything. You are not suppost to have any kind of buzzing. Check your starter wires.

[duh2150]

goosey i know im not suposed to have buzzing lol i got a fendanza 8 lb flywheel and exedy clutch plate and cover um im jsut trying to get it to crank its liek its trying to do somthing but it cant buzzing noiseand i dont think the starter is donig anything at all i cant tell when im in the inside but my dad i donno really its gonig a buzzing every time i try and start it up

[GOOSEY2099]

ok, hit me up on aim, yahoo and msn and i'll help you troubleshoot it

[bronxbombr]

the buzzing is either your stater or starting system. What starter are you using, did you change any wire harnesses. What kind of setup did you install, did you also install the NS switch from the clutch pedal or u running str8 tap off the Big harness, are you possitivley sure you did the swap right and didnt miss anything? These are the things we need to know. Oh ya did you take any shortcuts while doing the swap?

[duh2150]

something abotu the clutch pedal.. i too kthe 2 buttons off because they didnt hook anywere that i know of..

[solofantasy]

crank and not starting? right?

hahha either fuel or spark. Fuel pump or the relay/fuse. Have you touched those, cuz i had the same problem before with relay(i didnt something stupid and fried it)

coil for sparks. wire. plug.

[GOOSEY2099]

Once again, hit me up on aim!

[duh2150]

ok im gonna aim you lol its not cranking at all goosey maby you could send me some pics of all the wiring you did and area's and everything in detail wit hthe electionics