no start

[djmtz263306]

alright guys i have a no start issue right now , engine turns , at first my fuel pressure regulator hose was shootin off , then i noticed my intake was hot but not my exhaust ,

alright this is what i've done so far , all my timing marks are at tdc , my ditributor is set at 1 , all electrical wiring is conected , i do have fuel pressure i'm sure i have spark since my intake was burning hot ,

any ideas on what this could be ?

[Shadow19]

Sounds like a timing issue to me.. CHeck all timing marks and make sure.. once again... Just to be sure.. Also could be a bad crank position sensor.

[gaylantvr4]

also make sure you have spark just because something is hot dosn't mean you are getting good spark

[djmtz263306]

today i tried it again all timing mark are at tdc tried to start the engine when i noticed a puff of smoke from the engine and smoke coming out the intake :?: :(

[djmtz263306]

damn chilton book gave me the wrong timing marks i had to go back and look them up on All=data and on mitchell online. alson checked my timing by looking at the valves , finally car started just have to fine tune everything later down the road i'll end up rebuildin the whole engine with performance pistons , rods , dohc swap....etc

[bronxbombr]

I have Mitchell 7 if you need some more insight on this.

[djmtz263306]

yeah i think thats the same one we run