PDA

View Full Version : OIL



badmitsu
09-17-2007, 03:59 PM
I went through some wet oil on the highway today, I tried to wash it of but nothing, and its all over the side of my car. Anyone know any good shit to get this shit off?

minnesoshan
09-17-2007, 06:29 PM
degreaser, but i dont know if that will damage your paint

badmitsu
09-17-2007, 06:50 PM
def want something thats NOT going to screw the paint up.

Kwikfox
09-17-2007, 07:25 PM
Pressure washer will do the trick...

badmitsu
09-17-2007, 08:03 PM
pressure wash didn't work, it was still wet then though, I'll try it again tomorrow

Kwikfox
09-17-2007, 10:28 PM
pressure wash didn't work, it was still wet then though, I'll try it again tomorrow

Holy f'in shit batman... thats terrible... I don't know what to tell you... most of the chemicals you would use to remove the grease will damage your paint... Well try using the dry pink soap you get at like NAPA, or other automotive places like that, with the pressure washer... soap it up a lot, but don't rub too hard, just get a lot of lather worked into the area, than pressure wash the hell out of it.

fatal1
09-17-2007, 10:31 PM
simple green maybee but again not sure if it could damage paint...household item very strong cleaner

badmitsu
09-17-2007, 10:59 PM
i use to work at TruckPro, and still friends w/ the ppl, and they have alot of degreaser products, anywhere from hand soap to car washing shit, so i'm gonna check that out. But, other than that I guess i'm screwed until I get my paint job.

pinoyesv6
09-18-2007, 09:43 AM
dish soap should work. but you're gonna have to wax the car again.

badmitsu
09-18-2007, 11:54 AM
Found some good shit this time, Gunk Tar and Bug remover. Its badass Wal-Mart has it for $2.48 a can. Thanks for the help!

stkiflngaz
08-23-2008, 02:48 PM
what bout power wash with a little bit of degreaser in it

shockwave000
08-23-2008, 03:05 PM
quit trying to increase your post count with these old ass threads.

mapid145
08-23-2008, 08:41 PM
LMAO.. a newb telling a newb

RedGalant2k1
08-23-2008, 11:13 PM
I would have suggested a clay bar.

Ravyn
08-23-2008, 11:28 PM
i've used jig-a-loo its like wd-40 and that worked for me