View Full Version : Dome light led size
2000Galant
12-27-2007, 12:00 AM
somewhere i read that it's De3175 but on some sites it doesnt come out as that, but it comes out as for example ( 12 LEDs .75" x 2.5" LED Dome Light, Or 16 LEDs 1.25" x 1.25" LED Dome Light)
Which one is the correct size?
thanks in advance.
fatal1
12-27-2007, 12:06 AM
there is a bulb list on the site, i would check...but you will need to solder on any aftermarket one, or just wire up a few leds and solder them
mrjaydeeone
12-27-2007, 12:39 AM
here is the list craig speaks of
https://www.thegalantcenter.org/viewtopic.php?t=35393
2000Galant
01-28-2008, 02:59 AM
what do you mean by solder them?
djflex167
01-28-2008, 06:43 AM
what do you mean by solder them?
oh c'mon now, you should know this by now! :D
pinoyesv6
01-28-2008, 09:29 AM
what do you mean by solder them?
oh c'mon now, you should know this by now! :D
it sounds like you don't know the answer also...
but yea,
autolumination makes bulbs that look like they will just pop into the galant's factory dome light
http://superlumination.com/images/auto_bulbs/rl_cw_wm.jpg
http://superlumination.com/images/auto_bulbs/rigid_loop_w_wm.jpg
but the cheapest is like 8 bucks each. you'll need two of them so 16 bucks. then shipping.
when it comes to the dimensions of the led bulb for the dome light the biggest thing would be to measure between the two hooks. you want that to be as close to factory. the width isn't as important but the LED array should be small enough to fit inside of the dome light itself.
the more LED's the better. there are some bulbs that have better led's than some. and in that case, a couple of nice led's might actually be better than a bunch of crappy led's. it all depends on the specs of the led's
i built my own LED array like this one
http://superlumination.com/images/auto_bulbs/48_array_cw_wm.jpg
i dont think that one i posted will efficiently fit into the galant's dome light but yea, to fit that kind of led "bulb" or any kind of aftermarket one, you would have to have wires that connect the bulb to the dome light and to efficiently hold those wires onto the dome light, you would solder (you can get that at radio shack) and a soldering iron (it makes the solder hot) and practially fuse the wire and the terminals on the dome light together using the solder.
and just to be a showoff, these are my dome lights
http://img.photobucket.com/albums/v508/pinoyesv61/PICT0045.jpg
http://img.photobucket.com/albums/v508/pinoyesv61/PICT0044.jpg
http://img.photobucket.com/albums/v508/pinoyesv61/PICT0042.jpg
amdrocks
09-06-2009, 02:07 AM
did you have to put resistors for that or did you just wire the LEDs?
littlerick
09-06-2009, 10:59 AM
i didnt have to and i've got them in my dash and all my dome lights and they work great
vBulletin® v4.2.2, Copyright ©2000-2024, Jelsoft Enterprises Ltd.