Attn: Anyony with old VR4 sides

[Stewi]

How did you put them on? Did you drill into the rocker panels so that the OEM JDM clips have something to clip into, or did you just two side tape them on the rocker panel and then use the bolts/screws inside the wheel wells? I am not molding them, so if you molded them, no need to bother with that.

[fatal1]

How did you put them on? Did you drill into the rocker panels so that the OEM JDM clips have something to clip into, or did you just two side tape them on the rocker panel and then use the bolts/screws inside the wheel wells? I am not molding them, so if you molded them, no need to bother with that.

3m and bolt them in the wheel wells...on my old car i just dremeled off all the stock tabs and then put the 2 side tape on the top area....for shits and giggles you can shoot a few screws in through the bottom if you wanted to... but its not necisary

also im sure you know but fit them first if you are painting them seperately...no real mods need to be made to them but a little bit