To Anyone with an A/F gauge

[Fishboy55]

What wire on the PCM did you hook the gauge to? I've got the Autometer A/F gauge and it connects to the O2 sensor signal wire. However, I've got 4 possible connections for the O2 sensor in the PCM; two for the fron (left and right) and two for the rear. Which One do I use to get the most accurate readings??? Thanks.

Chip

[Lazarus]

Not sure which one exactly HCip but I can Narrow it fown for ya. there should be 2 black wires on the O2 correct? They are both Just Ground Wires. So It should be one of the other 2.

[Fishboy55]

<div class='quotetop'>QUOTE(Lazarus)</div><div class='quotemain'>Not sure which one exactly HCip but I can Narrow it fown for ya. there should be 2 black wires on the O2 correct? They are both Just Ground Wires. So It should be one of the other 2.</div>
Thanks CJ, but the gauge specifically says NOT to connect directly to the O2 sensor, but to do it at the PCM. I know I need to tap the signal wire of the O2 sensor, my question is just which one of the 4 should I use... I know several folks have an A/F gauge, I just need to know which O2 sensor is best.

Chip

[pinoyesv6]

http://www.eclipseforums.org/showthread.ph...&threadid=10458 ('http://www.eclipseforums.org/showthread.php?s=&threadid=10458') this might help u out...

[Fishboy55]

<div class='quotetop'>QUOTE(PinoyESV6)</div><div class='quotemain'>http://www.eclipseforums.org/showthread.php?s=&threadid=10458 this might help u out...</div>
Thanks Allan, that's perfect. The pinout might be different for the Galant, but what I needed to know was that I tap the Right bank, Front O2 sensor.

Chip