tom04841
01-04-2009, 01:09 PM
I got a line on some cheap 6 bolt 2.4l wiseco pistons.
Can I have the pin bore on the 1g wiseco's machined 1mm to fit the 22mm pin? If so, is there anything else i need to do to the rod since the pins are full float?
If not, Roughly how much would it cost to have the big end of 1g big rods machined to fit the 7bolt crank? And if machined, which bearings do i use now.....I would assume 7 bolt right?
Can I have the pin bore on the 1g wiseco's machined 1mm to fit the 22mm pin? If so, is there anything else i need to do to the rod since the pins are full float?
If not, Roughly how much would it cost to have the big end of 1g big rods machined to fit the 7bolt crank? And if machined, which bearings do i use now.....I would assume 7 bolt right?