fwd 4g63 to 4g63t(Vr4)

[1992Galant]

i currnetly own a 92 galant fwd 4g63. i want to know can i drop in a vr4 motor . with out convert to awd. and if i can swap the motor. what else would i need.

If i cant go vr4 . what about elsicpe gs. 2.0 dohc fwd. can either of them bold right into my trans.

[mko]

i hope youre talking about 1g eclipse FWD. and yes, you can drop it in, but youll need to figure out the ignition issue, cuz the SOHC 4g63 has distributor and eclipse has coil packs, but Im just guessing that the galant will adopt an eclipse engine harness w/o a problem.


for awd swap youll need everything out of vr-4 galant or 1g eclipse GSX. everything is compatible between these cars. youll need: awd manual tranny, manual transfer case, driveshaft, rear subframe and differential, awd gas tank, awd flywheel /6 bolt/, and bunch of other little stuff. It would be a lot easier and cheaper to find a junked 1g eclipse GSX to get parts from than buying them one by one or finding a Vr-4. Also, a lot of work. if youre not capable of doing it, or you dont have the place to do it, and want to pay some1 to do it for you then forget about it. just keep an eye on the car ads for Galant Vr-4 or GSX

[1992Galant]

i thought so. i was talking about a 1g eclispe. could i swap a 2g engine and trans. would that work

[4-G-rim]

E39a Galant VR4's have a different unibody frame and undercarriage from the FWD versions of the 6th gens. Basically unlike the 7th gens and 8th gens....there are no provisions and room to fit a rear subframe for the rear diff, driveshaft, etc etc. Basically...it will be extensive work and rewelding.

You can though swap a 6bolt 4G63 and just get the wiring harness for a FWD 1g turbo and its ready to go. As for swapping to AWD...its not worth it.

[mko]

i thought so. i was talking about a 1g eclispe. could i swap a 2g engine and trans. would that work


you could as long you do the wiring


E39a Galant VR4's have a different unibody frame and undercarriage from the FWD versions of the 6th gens. Basically unlike the 7th gens and 8th gens....there are no provisions and room to fit a rear subframe for the rear diff, driveshaft, etc etc. Basically...it will be extensive work and rewelding.

You can though swap a 6bolt 4G63 and just get the wiring harness for a FWD 1g turbo and its ready to go. As for swapping to AWD...its not worth it.


thanks good to know

[1992Galant]

i was just wondering. so my best bet would be a eclispe 1st or 2nd gen engine. with the ecu and wiring to that engine

[4-G-rim]

6bolt 4G63 from a 1g will drop right in and its "stronger" than the 7bolts. Not sure whats involved in wiring..but I would just buy a 1g wiring harness and a 1g turbo Eprom ECU and call it a day.

[1992Galant]

thats what i need to hear. i fond a gst engine and tranmisson for 1,000. its got 118,000 miles on it. its missing a alternator and a clutch. worth it or not. its a six bolt

[91gsx]

Just wondering if that tranny will hold up too or does a turbo explise trannybolt in

[QnzMostWanted]

the turbo eclipse transmission will bolt in, but the NA trans should hold up on minimal boost