axle diameter?

[8g831]

does anybody know the axle shaft diameter?.i wanna do the washer thing to pstop the vibrations that start after you lower your car...

http://www.galanttuners.com/viewtopic.php?f=77&t=570 <---topic

just wonderin if anybody can help,thanks alot guys

[SPD_FRK]

Shaft dia is 28mm (1 1/8"), the threaded section where the axle nut goes on is 21mm (7/8"). I am not for sure yet if we need the smaller or larger diameter, just know that it needs to be 1/8" thick

[Stewi]

you should test fit it, you want one that just barely fits over it, this way it stays somewhat centered

[Frankv]

Would a 1" washer fit perfect?

[SPD_FRK]

you should test fit it, you want one that just barely fits over it, this way it stays somewhat centered


Would a 1" washer fit perfect?

Based on the two measurements I was able to get earlier today a 1" may fit, but since this washer is being placed on the back side of where it goes through the hub I would imagine it is going to be the 1 1/8" washer needed. You don't want to use anything larger than that for hole diameter.

[Stewi]

Based on the two measurements I was able to get earlier today a 1" may fit, but since this washer is being placed on the back side of where it goes through the hub I would imagine it is going to be the 1 1/8" washer needed. You don't want to use anything larger than that for hole diameter.

correct.

in theory you want any washer in which the inner diameter fits over the axle, but fits fairly close so there isnt much play. and at the same time, one thats not larger than the hub diameter.

[8g831]

Update frankv did the work and put the washer through,sucessit doesnt vibrate anymore,beats buyin new axles