Installed - Billet Grille and Eyelids

[tr1kst4nce]

Ok so... you guys have seen me talking about it. Here it is finally. The car is a lil dirty cuz it's been storming, but yeah. I removed the factory grilles entirely and mounted them, rather than overlaying like it says to do.


http://i89.photobucket.com/albums/k204/tr1kst4nce/0430001355.jpg
http://i89.photobucket.com/albums/k204/tr1kst4nce/P1010094-1.jpg
http://i89.photobucket.com/albums/k204/tr1kst4nce/P1010095-1.jpg

[johnygezony]

Lookin fly, Get a cool plate up front and if you want to the lower grille done aswell. Love the fogs !

[Jeffylou87]

Nose delete ftw..

[tr1kst4nce]

Lookin fly, Get a cool plate up front and if you want to the lower grille done aswell. Love the fogs !

Yeah thats kind of the crappy thing. I go back and forth between here and Chicago... 1 of my cars is registered with Illinois, and one with Indiana, and this one use to be in Illinois... so.... leaves those ugly license plate holder holes.

[tr1kst4nce]

Nose delete ftw..

Huh?

[OMEGA PHX]

Huh?

He is refering to cutting the beak where the mitsu emblem is and get it even with the rest of the bumper.

IMO looks good as it is.

[rocgalant]

Nice stuff big guy. Side markers, turn signals, eyelids, fogs, grille. You putting a lip on there too?

[rez887]

Billet lower grill?

[madkilla]

hot looking g bro...

[Freehand]

how did u mount the billet grill without the factory grill behind it????

http://i35.photobucket.com/albums/d163/Californakid/2010-05-10193835.jpg

[tr1kst4nce]

how did u mount the billet grill without the factory grill behind it????


Sorry for the delay, been on vacation. Basically I took the factory grille pieces out, which was just heled in by a couple tricky tabs (pliers and a screw driver... pop them right out). Then I took some 8 inch long black zip ties and hoocked them into the rear weaving of the grille and then ran them through the slots that the factory grille mount up to. It's perfect because if you need to take them off, just cut, put a new one on, much easier, they are solid. I used 5 per side, they're black so you don't see a thing. Nobody has noticed yet.

Just go to ace hardware or lowes or something like that and they'll have a ton of diff zip ties. Just make sure they aren't too wide so they can fit through the slots in the back. 8 inches were the longest ones i could get in black that wouldn't be too wide.

[Freehand]

thanks man, I just finished and it looks alot better.

[makindue]

Looks awesome billet grille. How much did it cost you with that installation of your grille? :D