Sokhar
07-12-2010, 04:19 PM
Hey guys I ordered a set of headlights from JM auto and I need some help wiring up the HID kit. I am a noob at this so please bare with me here. (I also searched but I did not find the info I was looking for)
So where I am running into issue is how to power up the ballast and what the other set of wires is for.
The red cirecle is just the male and female plugs that match the male and female plugs on the ballest I have no issue there.
The in photo 1 the yellow circle plug goes to the ballast I am guessing to power it correct?
so the question is what do I do with the spade conectors on the other end of that wire?
http://i29.tinypic.com/2njfyu.jpg
Do I connect them to these female side spade connector? that should power up the ballast when both my daytime running lights and my Low beams are on correct?
http://i26.tinypic.com/vg0b3q.jpg
http://i32.tinypic.com/sy2syh.jpg
So where I am running into issue is how to power up the ballast and what the other set of wires is for.
The red cirecle is just the male and female plugs that match the male and female plugs on the ballest I have no issue there.
The in photo 1 the yellow circle plug goes to the ballast I am guessing to power it correct?
so the question is what do I do with the spade conectors on the other end of that wire?
http://i29.tinypic.com/2njfyu.jpg
Do I connect them to these female side spade connector? that should power up the ballast when both my daytime running lights and my Low beams are on correct?
http://i26.tinypic.com/vg0b3q.jpg
http://i32.tinypic.com/sy2syh.jpg