PDA

View Full Version : 02 galant v6 trans problem code p0733



cartunez
11-23-2010, 12:40 AM
ok i have a 02 v6 galant i had problems wit the trans when i got it goin into safe mode, i had a junk yard trans put in and it threw a output speed sensor code so i replaced it, now its throwin a p0733 code and it shifts 1,2,3 than stays in 3rd (limp mode ect), is there anything i can check or do??? im so fed up with this car lol
thanks in advance, i no im new here just heard this was a good forum :)

jermyjerm
11-23-2010, 10:24 AM
That's an incorrect 3rd gear ratio code,weird.Was the junkyard tranny out of a 4-cyl car?Not sure why else the gear ratio would be different.

cartunez
11-23-2010, 04:38 PM
na it was outta a v6 and i no what the code means just dont no y or if theres something i can try, a trans shop told me the trans is prob bad, the trans shifts 1st 2nd 3nd and a few seconds later does a little jerk and stays in limp mode, i can turn the car off than it will repeat the same thing

jermyjerm
11-23-2010, 06:02 PM
Sounds like 3rd is burned up.It shifts into 3rd,starts slipping which is sensed by the input and output sensors and is seen as incorrect gear ratio.

cartunez
11-23-2010, 07:52 PM
yea i dont no cause it goes into third smooth as hell, and if i dont let it go into 3rd it will automaticly go into it after a few sec

Faction
11-28-2010, 12:21 AM
this happened to me and i replaced the shift solenoid. now it shifts perfectly, if not, smoother.