Auto-9
10-08-2003, 05:09 PM
This is a relatively inexpensive modification if you don't want to weld on an aftermarket tip. It is a little known fact that the Stratus R/T Coupe (equipped with the 6G72 engine) shares the same exit diameter of the tailpipe for the V6 Galants - 2 inches. Its tip thus fits perfectly over our factory tailpipe. The Stratus's muffler though is further back than on our cars, and thus it has a shorter exit pipe. Here are some pictures of my car so equipped:
http://www.wbisolutions.com/TGC/tip1.jpg
http://www.wbisolutions.com/TGC/tip2.jpg
http://www.wbisolutions.com/TGC/tip3.jpg
http://www.wbisolutions.com/TGC/tip4.jpg
As you can see, I elected to go a little short on the exit, mainly because if I had left it far enough out where I'd like it, the inside pipe would look really ugly in my opinion (I tried it that way first). The overall effect though I'm sure you'll agree is that it's tasteful and doesn't really look out of place. If you're interested in doing this modification, the part number is MR497446 (Dodge, not Mitsubishi), it costs 39 dollars pre-tax. It does NOT come with the screw though, so you may have to pester the parts guy to find you a screw that will fit (I did not get the actual screw, but it's close enough). Just shove it on, and secure it with the screw. I'm sorry but I do not know if the 2.4L Galant can do this mod, as I don't know if the tailpipe is 2 inches.
http://www.wbisolutions.com/TGC/tip1.jpg
http://www.wbisolutions.com/TGC/tip2.jpg
http://www.wbisolutions.com/TGC/tip3.jpg
http://www.wbisolutions.com/TGC/tip4.jpg
As you can see, I elected to go a little short on the exit, mainly because if I had left it far enough out where I'd like it, the inside pipe would look really ugly in my opinion (I tried it that way first). The overall effect though I'm sure you'll agree is that it's tasteful and doesn't really look out of place. If you're interested in doing this modification, the part number is MR497446 (Dodge, not Mitsubishi), it costs 39 dollars pre-tax. It does NOT come with the screw though, so you may have to pester the parts guy to find you a screw that will fit (I did not get the actual screw, but it's close enough). Just shove it on, and secure it with the screw. I'm sorry but I do not know if the 2.4L Galant can do this mod, as I don't know if the tailpipe is 2 inches.