Originally Posted by
#1GALANTFAN
Now, for the dome light:
1. to take out the dome light housing, get a grip around the sides, maybe slightly towards the back, then carefully pull down, it should give in quite easily
2. Now, you need to disconnect the wires from the connector
3. Next you gotta take off the plastic cover so you can get to the dome light
4. In the middle of the housing towards the front where the button is to push in to turn on the light, there is a tab, this is where I had the most trouble, you need to push outwards on that tab to get it to snap off the whole plastic cover
5. Finally, take out the old bulb and replace it with the new bulb, make sure it's facing towards the open cover
6. After you install the light, to make sure it's completing the circuit plug the wires back into the connector, and see if she glows (if not, just flip it around)
7. Now put the plastic cover back on and the tab side goes where the little spring button is, it should snap right in
8. Then, just make sure it's lined up and gently push up on the dome light housing and it should go right in
Hope this helps anyone wanting LED map lights and LED dome lights in their 9G Galant.