Check Engine Light after CAI install
Ok... I will start by saying I put the short ram portion of the Injen intake on the 2.4L. I got the resonator out but lost day light before I could get the other part of the cold air intake on. It sounds AWESOME... I hear the growl and a little tiny whistle/hiss underneath... almost sounds like a turbo but not quite as loud. Performance is good... etc.
But now... the check engine light is on. I followed instructions I found here http://club4g.org/board/eclipse-perf...-cai-help.html regarding resetting/relearning the ecu after installing the CAI. But I thought the light would have gone off. However... I forgot to plug the harness back into the MAF sensor at first when I turned the key to "on" and waited the 2 minutes and I remembered... wait... I should hear a clicking. So I turned the key back to off... went back under the hood and plugged it back in. Then I restarted the process.
Turned the key to "on" and waited for 2 minutes. Turned it to off for 10 seconds. Then turned the car on and let it idle for 10 minutes. Turned the car off for 10 seconds. Then took the car for a 20 mile drive (about 30-40 minutes) and drove normal. Then after that I opened her up a bit to listen. I think it sounds good, I don't think there's leaks but like I said the check engine light is still on.
Is it because I forgot to plug the harness in the first time I started to reset/relearn the ECU? Do I need to go back and unplug the battery for awhile again tomorrow and then redo the process?
Isn't there a way to make it go off or... did I forget to do something? What? Any help? It's getting a little late so... tomorrow morning I'll go out and take a recording so you guys can hear. I'm 99.9% there are no leaks anywhere and it's all solid. But I guess I'll double check tomorrow. Unless that isn't causing the check engine light?
Let me know please.