Not sure if this is the right place for this but since it talks about electronics figured why not.
So my old overdrive switch wouldn't stay on (you had to hold it if you wanted O/D on). Decided to replace the switch with a lighted rocker that was going to go on the dash by the cruise control.
pulled apart the shifter knob and found three wires all leading to the O/D switch.
Black (had current when the switch is on), Red (constant 12v), and Yellow (light in instrument panel). Cut these wires and tried to hook them up to the new switch. got confused on which terminal to hook to wires so I used this pic.
http://www.customtacos.com/ubbthread...%20Diagram.gif
not sure if that diagram is right.I hooked up the black wire to the ACCessory terminal and the red to the power and black to the ground (the yellow hasn't gone anywhere yet)..but when I hooked it up it did not work and I lost being able to manually shift into Low and second gear (still does it automatically in drive though)
Does anyone have any ideas? Am I even wiring the switch up right? What should I do?
Thanks!