Got my clutch pedal but have a question

I got my clutch pedal, brake pedal, and shifter assembly from mko today. (Great seller btw) But I do have a question. I was looking through the tutorials and saw these pics on 4g63mightymax's hotrodcoffeeshop tut and was wondering what these electrical connectors are for since theyre not on the pedal I acquired. If they are needed for the swap, would someone kindly give me the part#'s.

here are the pics connectors in question are circled.
http://i10.photobucket.com/albums/a1...rcylinder8.jpg
http://i10.photobucket.com/albums/a1...rcylinder6.jpg

One is for the cruise control, the other one is for the ignition safty thing /you need to press the clutch to start the car/

Quote:

---

Originally Posted by mko

One is for the cruise control, the other one is for the ignition safty thing /you need to press the clutch to start the car/

---

i figured thats what it was but im going to take cruise out and i dont really need the ignition safety so.

Almost like the car is in park when you are going to start it.. I understand now.. lol

You dont need either. Just have to remember to pull it out of gear before you start it, or always press in the clutch.

you can still use the cruise control, its very simple to do

Quote:

---

Originally Posted by seth98esT

You dont need either. Just have to remember to pull it out of gear before you start it, or always press in the clutch.

---

thats how I had the Corolla.

Now just out of curiosity, where would you tap the wires for Cruise Control and the Ignition Safety?

Quote:

---

Originally Posted by mko

you can still use the cruise control, its very simple to do

---

Yeah im curious too on how to wire the cruise. If you dont have something written up ill just figure it out myself and add it to my tutorial. Im guessing match the same colored wires up to each other or something like that...?

To make the cruise control work you have to cut/remove/eliminate a wire from the cruise ECU harness, (pin #3, its a pink/green wire), located behind the center/lower dash, its visible in upper left of the picture; run a wire from the clutch pedal interlock switch (the one farther from the firewall on the clutch pedal) to the cruise ECU, cut cable pin #13 (black/yellow), connect that one (cruise ECU side, note wire position in the below pic) to switch pin #2 and connect pin#1 from the switch to chassis ground. It works, I tested it. I don't know if you have to remove the lower dash to access the connector (I don't think so), I had everything disassembled for the manual swap. Anyways, look picture below.

EDIT: added picture

http://i149.photobucket.com/albums/s...ofIMG_1475.jpg

I hope this is useful for someone else!

nice, but will it work on a 7g?

Quote:

---

Originally Posted by bronxbombr

nice, but will it work on a 7g?

---

Dunno, but should be similar