Kyb GR-2's and Tein S-Techs.
Don't take shortcuts, that was temporary while the springs that were already on order arrived, not while he saved up to buy them.
Printable View
Removed my alternator, I'm taking it in to be tested, with the somewhat scorched fuses I have been pulling out, it is either a short or the alternator
Spring are in. Little scared cuz the tires i put on the g (rear only) are already rubbing the fender
Any suggestions?
http://i27.photobucket.com/albums/c1...l/CAM00052.jpg
Also test fitted the rear reading laps from the diamante
http://i27.photobucket.com/albums/c1...CAM00053-1.jpg
Lastly purchased today resisters for my turning signals
Need some help with the wiring :)
http://i27.photobucket.com/albums/c1...l/CAM00054.jpg
Just connect it between the two wires for the turn signal. Plenty of pics on Google. Simple enough.
front end alignment after installing some new polyurethane bushings. My god my toe was off -2.16 degrees left and -1.65 right hahaha
Put on a timing belt 2 weeks ago water pump, crank sensor, gates kit and new hydrolic tensioner then went and bought and put on this week these.
Cat back exhaust
OBX-R header
2 o2 sensors
Painted the engine block and cyl head and valve cover
halo projector headlight and fitted them so no gap like factory
New 5000k HID kit
20x 20 Smd cards leds for the halo's
Window rain guards
Front stuit tower bar polished
I think its called a rear tie rod end bar under polished
Good looking used leather Ses air bag drivers seat
Like new carpet put in
Put multi colored led strip with controller under dash and under rear of the front seat for the back floor
New heater control cable for the knob the other one bent
Used starter cover and painted
After market tranmission cooler
Used passenger Plastic that goes around the fogs
Passenger A pillar plastic interior
Sanded and polished the hole car "still working on"
Painted the inner fender black and painted the rotors and calipers and drums
Put a hood, fender, decklid on same color last week
New strobe stripe decal for the fender since I replaced it.
Looking to get some wheels after X-mas and new quarter panel and lowering it like my other one. I have been really busy on it for the last two weeks, just have not got around to posting anything.
Damn... got any pics of the progress?
When I get time I will post some just really busy with other projects and it is still wet sanded.
The rims for the G arrived this past friday.:smilegrin: They are 17x7. Now have to get tires, springs and struts. What you guys think of the new wheels?
http://img22.imageshack.us/img22/303...2121400001.jpg
pulled my alternator to get it tested, and it's ok (amazing for a 13 year old alternator from the factory), however in my pulling the car briefly apart, I haven't been running an idler for my accessory drive belt for the last 4 months, later I charged my battery completely and tuned on the headlights, nothing happened, fogs work, still this isn't a change
so I'm down to the battery, a short or the harness to my remaining headlight is burned out, I've got a feeling I've got at least one burned out harness or switch if this isn't a short, I really hate tracking down shorts
My damn horn on the daily stopped working. The funny thing is after a new horn it doesnt work. Took my test light to verify that it was getting power and guess what it is getting power. So I cant figure why in the hell this bastard stopped worlking
Plates in today, picture day tomorrow.
Uninstalled the duckbill trunk
http://i243.photobucket.com/albums/f...ps7eb2ff17.jpg
and installed the sss spoiler back on the X
http://i243.photobucket.com/albums/f...ps309c46fc.jpg
Yo z u still got the g........nice pick up
Sent from my PC36100 using Tapatalk 2
Nice, I like the high rise spoiler look on it better too! Any pics of the new g?
GT Wing > Duckbill > *