I'm curious, how are you getting around using a MAP sensor?
Printable View
I'm curious, how are you getting around using a MAP sensor?
Well, the ITB plenum is on backorder.
Build one out of sheet metal. Just steal a road sign, cut it up, have a welder stitch it together. done.
My buddy made his intercooler end tanks out of a stop sign back in the day. lol.
Or fiberglass.
I misspoke, manual shaft is a few mm longer.
Haven't got around to put them on, been busy lately. Also working on something else for the car.
Like doesnt sound smooth yet. But get that tune done and presto nastyness
It's always gonna sound ratty with an ITB setup on it... No resonance of muffling from an intake. It's very raw.
that is f^^ck!nQ cool bro, I don't know how you made that work but props to you!! whats next??
I think you shoudl make a big fiberglass intake plunum. Then duct it to your stock MAS
Too bad you're not local. The R&D stuff you've got going on is insane.
LOL. I wish there was someone local to bounce ideas off and apply them. But what I have done so far, isn't as expensive as most people will think it is. I have a spare fed spec header to mock up a custom 2-1 and I have a spare XG runner section which I plan on having injector bungs weld into them near the base of the runner to inject fuel down the lower intake manifold.