How To: Install Neons Or L.E.D.s
how to install neons, the directions with the kit is only 5 long and the 5th says ENJOY lmao!
1. buy the kit from streetglow.com or any other place you can find it, i bought mine at advance auto parts
2. open the hood, disconnect the POSITIVE on the battery, and install the transformer that is supplied in the kit
http://i207.photobucket.com/albums/b...Picture050.jpg
http://i207.photobucket.com/albums/b...Picture051.jpg
3. start with the front, there really isnt a place under the car so i hid mine behind the lower grill, was a pain to squeeze in but it fits, ziptie it in since you wouldnt want to bolt here AND zipties are better (thankyou mrjaydeeone for the tip)
http://i207.photobucket.com/albums/b...Picture056.jpg
4. run the wire attached to the front one up threw the top grill and along the hood to the transformer
5. jack the car up to have one side up
6. if you want to hid the tubes on the sides, you have to drill 3-5 holes that you will ziptie the neon to
http://i207.photobucket.com/albums/b...Picture060.jpg
7. repeat for the other side
8. for the rear, take out the screws that hold the bumper to the car BUT leave in the 2 bolts that are there. on my 99 there was 6 spots, two had bolts and 4 were screws
http://i207.photobucket.com/albums/b...Picture064.jpg
9. ziptie the neon threw these holes, do extra zipties if you wish
http://i207.photobucket.com/albums/b...Picture066.jpg
10. get the switch for inside the car hooked up, hard to get the camera in for this but pull up the carpet a bit and you will find a black "plug" that u can pop out MAKE SURE YOU FIND IT make a cross in it with a blade and run the wires threw that into the car
http://i207.photobucket.com/albums/b...Picture067.jpg
11. run the other side of the wire threw a space under the car to the top without touching anything hot or moving
http://i207.photobucket.com/albums/b...Picture053.jpg
12. connect the transfer wire to the transformer box and the positive wire to the positive of the battery
13. run the driver side wire up threw the same spot that you did the switch wire (may have to strip and add wire to it)
14. add wire to the passenger side and run that up threw a hole on the passenger side and ground the negative and insert the positive into your transformer, hard to see but there is a hole down there
http://i207.photobucket.com/albums/b...Picture058.jpg
15. on the rear neon, split the wire and ground the negative to the tail lights, add ONE long wire to the positive side and run it up the side of the car to the hole where the side one went up and then to the transformer
16. hook up the battery and try it out
http://i207.photobucket.com/albums/b...Picture048.jpg
http://i207.photobucket.com/albums/b...Picture047.jpg
^ that is why you should hide it on the inside of that bar
http://i207.photobucket.com/albums/b...Picture046.jpg
^ that is hidden inside compared to the other side
any questions, i will do my best to explain more
p.s. most people say this rices it but i like neons personally and this took me around 5 hrs since i had to have people help me drill and do the wiring and the instructions that come with it are only 5 steps, make it easier then it is
DISCLAIMER: IF YOU MESS UP, CONNECT SOMETHING WRONG AND IT BREAK OR BLOWS, OR ANYTHING ELSE, ITS NOT MY FAULT