Integra Mugen Lip Install
After numerous requests for "how did you get that on your Galant" I decided to post a "tutorial" - not a real tutorial I guess, cuz A) Theres not much to it and https://www.thegalantcenter.org/styl...fault/cool.gif I didn't have the right tools so I don't know the best tools to use. But anyway, here goes.
Firstly, I got my JDM Integra Mugen Lip from Ebay for a 98-01 Integra. They are all over, and mine is ABS Plastic and hasnt had a single problem at all since installation.
All I had to do was heat up the edges of it and re-bend them to fit because the bumper of Integras are slightly longer than Galants, then had to do a small amount of cutting in the middle of the Integra lip to contour with the opening of the Galant "mouth" area. Heres some pix of what I did. The red arrows and lines show where I cut:
http://memimage.cardomain.net/member...67_30_full.jpg
http://memimage.cardomain.net/member...67_31_full.jpg
http://memimage.cardomain.net/member...67_32_full.jpg
These next pics show how I bent the lip with heat to fit the Galant:
http://memimage.cardomain.net/member...67_33_full.jpg
http://memimage.cardomain.net/member...67_34_full.jpg
Using the long-stem lighters someone would use to light a grill :roll: it took me 2 hours to finish this project. I had two other bolts in the middle of the lip as well in the "mouth" area but they fell out, but the lip holds up just fine anyway. Let me know if you have any questions.