Replace Door insert to Vinyl
Ok! Been awhile since I've been able to customize the G!
Following whats been said HERE I took my hand at this.. Unfortunately I didn't realize how long it'd take to figure out how to remove the rivets that remove the cloth piece from the door, so i'm continuing onto today. Started with the backs also as it is way easier.
Soo at the "Remnant" isle I picked up 2 yards of Black Vinyl & some of that Super 77 Spray Adhesive by 3M for $20.. Spray was $10.47 or something..
Using a standard Flathead & Phillips, & Kerosene as a replacement for removing the sticky glue left over Pics will follow throughout today. I'm also skipping removing the Door insert from the actual door frame as this is a straightforward process..
So! 1st!
http://i13.photobucket.com/albums/a2...h_c8ab7537.jpg
After removing the door frame from the car, That black foam piece is gonna be the easiest to remove.
Then you can remove the Window Switch http://i13.photobucket.com/albums/a2...h_ebdfd703.jpg
It has 3 screws, 2 on the front and then this one on the bottom.
http://i13.photobucket.com/albums/a2...h_9d1a70b7.jpg
Sooo, Everyone has different ideas of how to remove these tabs, I heated up this
http://i13.photobucket.com/albums/a2...h_c71867aa.jpg
and melted the tabs as best as I can to where they just slide out, but as you noticed I butchered it..
http://i13.photobucket.com/albums/a2...h_d465363b.jpg
And here is the cloth piece sprayed & soaked in kerosene, then scrubbed to hell to try and remove that stuff.
http://i13.photobucket.com/albums/a2...h_4839082b.jpg