Now that circuit city went under ill have the time needed to start and finish my 7g... Over the next few weeks ill be posting progress and i hope to move pretty fast with it. Any comments, positive or negative are welcomed as well as ideas, dont be afraid to speak up i assure you i wont lose any sleep over it!
Also this is going to be a full build and i know its messy now but it will be cleaned up so dont worry about that..
All of this was done yesterday when i found 2 hours of free time between errands.
Out with the 275's and in with the 450's
http://c2.ac-images.myspacecdn.com/i...87d9abeabd.jpg
Again with resistor pack (not installed yet)
http://c1.ac-images.myspacecdn.com/i...7786ca4c50.jpg
Fuel rail out
http://c2.ac-images.myspacecdn.com/i...61723754b9.jpg
Fuel rail back in and test fit vr-4 strut bar
http://c4.ac-images.myspacecdn.com/i...bc1a9dd567.jpg
Maft mounting location
http://c3.ac-images.myspacecdn.com/i...ff3f5b76ce.jpg
Teaser pic
http://c1.ac-images.myspacecdn.com/i...9fc9be5070.jpg
Vr4 wing FTW
http://c4.ac-images.myspacecdn.com/i...0c30ddd81f.jpg
And another
http://c4.ac-images.myspacecdn.com/i...6ee1f743d3.jpg
And project for 2morrow if its nice out
http://c4.ac-images.myspacecdn.com/i...4be8163c57.jpg
-Python 460 hp security and keyless entry
-Audio sensor
-Dual zone motion sensor
-4x Door lock actuators
-Trunk release
-2x Relays
I may also run my FMIC pipe 2morrow..