Catch Can Homemade from Argentina
There are commercial quantities of oil vapor filters (catch can, pcb mod, catch tank?) Going around in internet
even it can buy but they have inside?! and compressor water trap seems very light.
for that reason I decided to do so.
From what I saw take what seemed to me more functional.
Discard the first proposal with the aluminum bottle because at some point I want to see what happens within
and it is impossible to open. But with the thin walls of this they may have missed and to introduce a material
to condense the oil in a gaseous state?! depending on whether it is possible that this will be the admission by accident.
proposal:
final sketch
http://img541.imageshack.us/img541/4607/29954089.th.jpg
as shown in cropuis fumes go straight to the bottom of the bowl hitting the lower wall
must pass through the first trap consists of material and the second trap capacitor consisting of two
grids. The conical filter on top, according to my understanding is if the pressure of the steam is too much, as
an alternative exit in case there is an obstruction within the vessel.
obviously you have to add a key at the bottom despurgue and a viewer of the amount of oil.
A brief review:
Thus began
http://img541.imageshack.us/img541/299/oxxj.th.jpg
Grids
http://img697.imageshack.us/img697/9009/10281360.th.jpg
going from left to right ...
http://img63.imageshack.us/img63/3706/70682487.th.jpg
turned out that there was no available space was to change the way
http://img94.imageshack.us/img94/3111/19436975.th.jpg
http://img704.imageshack.us/img704/4500/58605100.th.jpg
http://img63.imageshack.us/img63/2450/76954863.th.jpg
http://img63.imageshack.us/img63/482/54983700.th.jpg
Lower and upper
http://img576.imageshack.us/img576/6295/32921059.th.jpg
http://img149.imageshack.us/img149/9145/86078455.th.jpg
http://img63.imageshack.us/img63/2995/87861930.th.jpg
http://img641.imageshack.us/img641/3200/35185422.th.jpg
And now as I hold it?
http://img263.imageshack.us/img263/1821/22774987.th.jpg
To eventually be opened
http://img63.imageshack.us/img63/6991/33708499.th.jpg
Final disposition of rust-free condenser elements ...
http://img63.imageshack.us/img63/1351/75118346.th.jpg
Preparing for the background creating printing (given the short time with which to do conte di overlooked
fine details)
http://img63.imageshack.us/img63/9109/jxxz.th.jpg
Vehicle Color matching
http://img411.imageshack.us/img411/4308/77289650.th.jpg
and since this lacquer
http://img294.imageshack.us/img294/6066/39248842.th.jpg
Finished piece
http://img101.imageshack.us/img101/3753/84529267.th.jpg
Installation complete
http://img63.imageshack.us/img63/5210/68000315.th.jpg
http://img685.imageshack.us/img685/2779/51146961.th.jpg
Is currently being tested as it was then I will comment and I will give a conclusion in this regard.
