-
Member
need help buildng motor
Where can i find pistons and rods for the 8th gen galant?
-
Member
Has anyone built this motor before?
-
-
Member
-
http://www.importperformanceparts.net/impo...mitsubishi.html
scroll down to the bottom u will see parts for the 3g eclipse/galant 4g64 not sure bout the rods though.. it says pauter rods are available but then its not listed... u might wanna call them up to check
-
Member
thaxs alot
-
If you cant find any rods, just shot pein your stock rods. Should make them stronger.
-
first, you have to decide if you're going to overbore, and then you just need to find pistons and rods in the size you need with the compression you want. it all depends on where you're going
-
Member
<div class='quotetop'>QUOTE(peanotation)</div><div class='quotemain'>first, you have to decide if you're going to overbore, and then you just need to find pistons and rods in the size you need with the compression you want. it all depends on where you're going</div>
the biggest i would want it is a 2.8 and i want to run 8.5 compresion. Im also planing on sleaving it.
-
Your blocks have sleeves?
Posting Rules
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks