Ok so here's wutz goin on.... I just got my dual halo projectors from Eric not too months ago MAX, with everything goin on I JUST NOW got to the wiring. Problem is I'm horribly ignorant in the electrical engineering field..... Now I have a 3 prong switch to turn the halos on/off, Ground prong is grounded, halo wires are connected to the load prong, and I was TRYING to just test em out the lazy way and stick the power wire in with my lighter fuse but then it all went downhill...... I blew my ignition fuse which I went and replaced, and I even got an inline 30A fuse for the power and I STILL blow the little MTA fuse every time..... somebody please tell me what I'm doing wrong here lol Thanx in advance