you gots to heat it up yo!
ok...i purchased a 98-01 integra mugen lip. i just got it today and it looks pretty decent. my only complaint is that it seems to be very hard like almost too hard to be able to conform to my front bumper. its says that its made out of abs plastic but it i thought abs was a little more flexible. is this how it is supposed to be? any help would be well appreciated? thanks in advance. peace!
2001 es v6
you gots to heat it up yo!
Got a Harbor Freight tool store? http://www.harborfreight.com/cpi/cta...emnumber=35776
lol.....i figured that i would definatly have to heat this thing up to get it to form. thanks for the reassurance and good looking out on the harbor freight tool store site. thanks guys. unfortuantly im in maine and there is still massive amounts of snow on the ground so i will probly have to hold off on this little project til spring. but ill keep you guys posted. i think imma take my time and mold this lip right onto the bumper. again......good looking out, i definatly appreciate it!
2001 es v6
a dremel and a heat gun will be ur best friends in this project...i used a custom heat gun..lighter and axe lol
2001 5 speed 4g64T
Hehe, I used a propane torch instead of a heat gun.
RIP: Colin McRae, you will be missed.
"I shall go before thee and make the crooked places straight."
2001 ES V6 M/T under construction
1991 Volvo 244ti 300 whp daily driver
www.gooichimotorsports.com
a novice using a propane torch may actualy destroy the project by burning a hole in the middle...
probably in the tutorials section.
or here:
http://www.galantwiki.com/index.php?...p_Installation
Bookmarks