Possible bad head gasket

**peanotation** · 12-24-2009, 08:19 PM

check to make sure the bottom of the head is super duper level and flat. might need to get it milled if not, no biggy though, you're probably good.

**The Kent** · 12-26-2009, 01:56 PM

Originally Posted by peanotation

check to make sure the bottom of the head is super duper level and flat. might need to get it milled if not, no biggy though, you're probably good.

Getting that done shortly. $5 to check for level and $30 to mill it if out of level.

**peanotation** · 12-26-2009, 09:28 PM

holy COW that is a deal. RRE wants $90 to mill my DOHC head.....they're overpriced bastards though

**The Kent** · 12-27-2009, 10:29 AM

It is pretty cheap. I have to drive to Brunswick, GA from where I'm at which is 30 minutes south. But hey, $35 if it is out of whack isn't too bad.

Thread: Possible bad head gasket