Looking at drop need advice

[allrice4g64]

you would still need a camber kit.

[krow]

would a 4 wheel alignment fix it?? or would i for sure need a camber kit?

To do the alignment right you need the camber kit.

[03silver8g]

would i need one for the front and the rear??

[OMEGA PHX]

would i need one for the front and the rear??

It depends, in the rear your most likely going to need one iirc Reelax stated on other thread that if you drop it more than 1.75", on the front you shouldn't need it but to be sure you need to drop the car and go get an alignment and they will tell you how many degrees of camber you have, if its between factory specs then you don't need one for the front.

[03silver8g]

okay thanks that is helps me out alot. where could i get one for cheap??

[E_Emerson88]

Home Depot =]

[OMEGA PHX]

Home Depot =]

To explain a little more the home depot rear camber kit (you'll need to do your homework I already got the links for you so read them and you'll know):

On this link on the first post you'll find a RRE link to some pictures so you know how to do it:
https://www.thegalantcenter.org/show...e+depot+camber

More info on the HD camber kit:
https://www.thegalantcenter.org/show...e+depot+camber

This link is the direct link of the bolts you need to buy exact length, hardness etc:
http://www.clipsandfasteners.com/Pro...17191&CartID=1

The box of bolts includes 10 bolts you just need 8 so 1 box is enough to do your car.

[03silver8g]

so i only need the bolts and washers, and just replace stock ones and out the washers in and we are good?

[OMEGA PHX]

Replace the 4 stock bolts per wheel, and put the washers like on the RRE pics is shown, but you would need to try and get a alignment after dropping it so you know your camber specs so you know how many washers you need, on one of the threads someone say that 5 washers on each bolt take 1 degree of camber off but I can't find the thickness of said washer so I hope someone who have done it chime in.

[03silver8g]

me too. im doing my drop Wednesday.. i think i might just put them in while i am doing the drop then i dont have to pay for 2 allignments.

[OMEGA PHX]

someone say that 5 washers on each bolt take 1 degree of camber off but I can't find the thickness of said washer so I hope someone who have done it chime in.

So In the next couple of weeks I'm going to need a rear camber kit, I'm planning on going with the "Home Depot kit", I already got the link for the bolts, but I haven't found the size of the washers I need, can anyone post a link of the necessary washers? Since I'm going to order from clipsandfasteners.com any link from there would be nice, Sorry to revive this but I figure it would be better than starting a new one, thanks in advance.