Log in
Register
Reply With Quotewhat are you talking about?
ok, so i took my heads out today in an attempt to clear my corners, here were 800 little notches that i didnt wanna break, so i went to auto zone to see if the could do it for me, they said that if i take it apart, then the reflector is gonna be hard to get out, and that water will get inside the heads after puting it together.. any suggestions on what i should do? how did any of you guys do this?
what are you talking about?
@OP your post is a little confusing
I did it through the bulb hole pulled it loose, and then broke it with some needle nose pliers,
or you can bake and separate them and then resale I can assure you that if you seal them right they won't fog or get water since I've done it myself
Last edited by OMEGA PHX; 10-19-2010 at 08:46 PM
4g64T 5spd
800 little notches??? Lol
Not exactly sure how your trying to go about it...
Maybe try this-
https://www.thegalantcenter.org/show...leared+corners
You don't have to take the headlight apart. I just bent a flathead screwdriver and stuck it in the turn signal bulb hole between the headlight and reflector piece and pulled..Then break up the rest of the reflector with some sheet metal shears or whatever and shake it out like a rattle toy.
I expected the Rocky Mountains to be a little rockier than this.
Its Easiest to use pliers with cutters on them. U jus break reflector into 5,920,380 peices an shake em out.
2001 Mitsubishi Galant-Totalled..=(
1987 Cheverolet IROC-Z Camaro-TPI 350
1989 Nissan 240sx-built SOHC-Trade for Honda
1999 civic Hatch B20vtec- current
Lookn for galant to build. .
I had the clear corners now I have the 02 heads n smoked the reflector.
FreakyDeaky
2kG 6g72/74 5 speedOriginally Posted by sponcar
hey thanks everyone, i followed the link that one of you gave me, maybe now i can make a photobucket and finally put some pics up of the lights, and the drop i recently did
How did you smoke them? I did my tails, and i was thinking the same thing...
-Andrew
I open them up in the oven n with nightshade lightly smoked them looks alot better look in my pic thread the newer pics have the smoked reflectors.
FreakyDeaky
2kG 6g72/74 5 speed
Think i could get away with doing it on the surface? I don't think i can use the parents' oven and get away with it... Haha
-Andrew
Its not that hard or takes too long to open them its worth it although 02 heads look sick cleared.
https://www.thegalantcenter.org/show...377#post616377
My pic thread
https://www.thegalantcenter.org/showthread.php?t=41313
My how to open up ypur heads thread.
FreakyDeaky
2kG 6g72/74 5 speed
Yeah i thought about getting '02-'03 heads/tails... Not sure yet. Gotta check pull a part
-Andrew
Posting Rules
2001 Mitsubishi Galant DE
Bookmarks