Post What You Did To Your Car or Bought Today!

[oakrdrs187]

Distribution block or not im gonna go ahead and assume they aren't all power lines. Should have drilled not chiseled 2 separate holes with grommets.

Sent From My Rooted Galaxy Note 2 using Tapatalk

[coconut]

^Agreeing with ya!!

[carl3g]

I bought one of these

[coconut]

^congrats!!have couple myself .safe riding!!

[demond0d5]

That's exactly what I'm going to do on both accounts. Dremel was fucking up (kept pulling the bit out???) and couldn't find my hole saw kit but it's going to be redone within the next week. I have a new fuse box sitting the the glovebox, just haven't had the time to fix it all up yet.


Sent from my iPhone using Tapatalk

[demond0d5]

Oh and half of them are grounds anyway, only 2 are hot at all times (sub and inverter). Also my wideband stuff from lc1...


Sent from my iPhone using Tapatalk

[juicejax]

Black Diamonds


Dipped my diamonds today... Excuse my dirt been raining a lot lately

[SNWFLK]

^ car looks pretty damn clean man from what we/I can see




Just purchased my timing belt, need the tensioner, water pump, control arm bushings, motor mounts/tranny, crank seal, oil seal, other belts, yadda yadda. Hopefully it gets done before the meet. Still need tires and those damn coilovers on.

[juicejax]

^ car looks pretty damn clean man from what we/I can

If You look on top of the trunk its covered in dirt, but thanks tho lol

[SNWFLK]

Yeah I see that but the paint quality looks pretty good

[juicejax]

Yeah I see that but the paint quality looks pretty good

Yea the paint is still decent think it was repainted before I bought

[dronesurfboards]

went to the junkyard and got another HVAC and found the brackets for the dual piston calipers. Gonna try to go back next week and see if I can find a rear disc and clean set of dual calipers

[beam514]

I bought one of these

Man that's a nice looking bike. I've been thinking about one a bit lately... and in white too...

Anyway today I finally reassembled the dash after driving without it for about 2 weeks to locate some rattling. Added a bunch of stick-on felt in a bunch of plates so hopefully that gets rid of the damn rattling! Also removed the spoiler because one of the threaded inserts was broken. I'm not sure if I'll try to fix the spoiler or just go without it for awhile.

[foxbrand]

Well, wasn't today, but yesterday, most of my bearing set came in, except for the thrust bearings, which are on further back order than undersized mains and standard size rod


Also last night, a distributor for the Honda, a fuel pressure regulator and upper intake manifold for the Chrysler, and a new IAC for my Galant

[juicejax]

Did a horrible plastidip job on my chrome window trim...stuff is pretty fun tho

[juicejax]

^^^

[Mr. Bishi]

picked up a 5spd tranny over the weekend

[Black8GV6]

^ You sir have HUGE BALLS to put that in the cabin area, THAT IS LEATHER.

[coconut]

Smdh!!!

[Mr. Bishi]

^ You sir have HUGE BALLS to put that in the cabin area, THAT IS LEATHER.

Had a piece of wood underneath across the backseat and plywood to the back of it. Took it slow all the way home only an hour drive.