will this fit in my o2 gtz

[galant1983]

this guy is selling this and i wanted to know if it will fit?


I have up for sale my 6A13TT with 1.8 Manual trans

JDM 8th gen 6A13TT (2.5L Twin turbo V6) ~95K Miles
Wiring harness and ECU
XS Boost controller

F5M42 Manual trans *grinds into third under load* (Fits in 5th gen Mirage unsure of other mitsus)
Shifter cables and base
Clutch pedal assembly with Neutral safety switch
Slave cylinder
Master cylinder

[Joshua42007]

I dont believe you can swap a JDM engine into a USDM specific vehicle, unless you plan on doing a full RHD to LHD conversion. Someone correct me if i am wrong.

[showtime]

motor sits totally different, lots of custom fabrication is needed for that. if your v6 go get a 6g74 or 6g75 if you want to do an engine swap.

[RedGalant2k1]

Yes, that is if you want to spend about $5000 just to get the motor to fit and wired to your car. Excluding the cost of the motor itself.

[HondaKillerGTZ]

Yeah go get a 75 and you'll have the same power minus the turbo lag. You will also have spare parts available so much easier!!!

[M-Rod]

for sure the 75. I'm about to have a small surplus of the parts needed to swap if you need anything.