-
NEWBIE
03 2.4L - auto to manual conversion
My account can't post in the 8g technical section, so I hope this is the correct forum.
Did lots of searching, and I hope i pieced a lot of this together properly. Tons of links were dead from the original guides
2003 galant transmission swap parts list
----
all from a 3g eclipse - 01-05
5 speed manual transmission
clutch pedals
master cylinder
slave cylinder
shifter assemply
flywheel
clutch
clutch lines
manual trans mount
transmission bolts from a ???
to remove CEL on 2003 galant
----
flash the ECU with a Tactrix cable and ECUFlash and simply disable the immobilizer on our ECUs rather than buying another one that has already been disabled.
wiring
----
CONNECT PIN 5(BLK/YEL) + 8(BLK/BLU) TO START THE CAR
CONNECT PIN 7(RED/GRN) + 6(RED/BLU) TO TRIGGER THE REVERSE LIGHTS
For the reverse lights, you just need to connect your reverse solenoid (on your transmission) to the correct two pins on the B-39 connector
Use the 2pin connector on top of the tranny to connect the 6+7 that should be your reverse gear selenoid.
only 02-03 models need a full speed sensor harness to wire into the cluster.
speed sensor
----
Run two new wires into the cabin. since your using the m/t, you splice those two wires into the speedo sensor on the tranny. the other two wires you splice into the main connector that's under the dash (it's connector C-17-look in the manual to locate it) Pins are 3 and 4.
Anything else I'm missing? All of that look correct?
Posting Rules
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks