for those who own JDM flares

[Dominicano]

wanted to know besides those who got the weatherstripping for the JDM flares from Toru, did anyone use something else instead?

[deeznutz]

Yepp you can use the same striping as Toyota Honda or any other suv with flares....

[Isaurio]

^x2

Toyota Part number OEM #75625-0C010-C0

[Dominicano]

thanks for the help! so I would have to get 4 of those to cover all four right.

[Galantman03]

Yeah, i got mine from toru, and the 4 pieces covered all six of the flares. Just gotta cut them to fit

[deeznutz]

thanks for the help! so I would have to get 4 of those to cover all four right.

Yes... I got 4 for a Toyota sequoia covered all 4 flares with extra just cut off excess and your done. They also have double sided tape on both sides so they stick to the flare and the body.

[deeznutz]

Yeah, i got mine from toru, and the 4 pieces covered all six of the flares. Just gotta cut them to fit

Bet u paid out the ass!!!

[Dominicano]

Yes... I got 4 for a Toyota sequoia covered all 4 flares with extra just cut off excess and your done. They also have double sided tape on both sides so they stick to the flare and the body.

Nice!! i like that i am trying to see how i am going to mount these cause I plan to go with some wheels with a 35 offset so will need to roll my rear fender.

[Galantman03]

Bet u paid out the ass!!!

I think like 30 bucks

[Dominicano]

I think like 30 bucks

what about shipping?

[Galantman03]

Lol idk guys. They fit in a small box

[deeznutz]

Nice!! i like that i am trying to see how i am going to mount these cause I plan to go with some wheels with a 35 offset so will need to roll my rear fender.

Slight roll not much needed for a 35 offset depending on tire size. I'm running a 30 offset on a 225/40/18 and 0 camber only needed to roll half the lip wit a couple of mm of clearance it's very close thou

I think like 30 bucks

That's actually not bad I don't remember who but someone else paid 3 times that for that crap.

[Dominicano]

Slight roll not much needed for a 35 offset depending on tire size. I'm running a 30 offset on a 225/40/18 and 0 camber only needed to roll half the lip wit a couple of mm of clearance it's very close thou

If that's the case I might just cut instead.

[deeznutz]

I don't recommend cutting and for good reasons it weakens your panel after u cut it it has to be welded because the lip is the bond between the panel n the well then painted so it don't rust you'll regret cutting, just roll it it's a better n smarter method. I cut my jettas lips my quarters warped from the welding i had to do body work and repaint half the car worst thing I ever did!!!!

[Galantman03]

X2