-
need help Please Please
need help please please
hey there everyone
got 03 ES 2.4 manual seats cloth upholstery
unfortunately accidental spill (atf) occurred on butt cushion of my rear seat it's ruined
local salvage yards had only cloth rear seats all "worse than mine"
but did find a full LS leather interior at junkyard but now have the driver pwr seat to deal with
anyone know if lower trim levels share same wiring loom with LS model? i'm Praying that DE & ES
all rolled out of factory pre-wired for pwr driver seat cause woulda been more expensive/difficult for Mitsu
to produce 2 unique wiring looms
as always thanks everyone for your help
i'm hoping I'm not gonna have to use the alkaline battery trick/
jumper the seat on foraminute to be able to fasten it & then just set it & 4get it in an ok comft seating position
-
New Member
I would tap it into another line if it’s not prewired. I was thinking about putting power seats in mine. Hope this helps.
Sent from my iPhone using Tapatalk
-
thx for your help ---- i wonder
[QUOTE=justin13;820976]I would tap it into another line if it’s not prewired. I was thinking about putting power seats in mine. Hope this helps.
----
thx for your help --- i haven't removed my orig manual seat yet & placed side by side ((upside down)) & compared
to see if i could just change that & somehow get power seat converted to manual by swapping base since I don't wanna screw with wiring ? don't even know if this is possible -- anyone out there know if it's possible to mount manual front & back slide adjust to a pwr driver seat from LS model?
Last edited by 03gsedan; 12-08-2017 at 03:10 PM
Posting Rules
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks