Wiring throught the firewall

[BlaqueOut]

Aight, I know many of yall have done some wiring. So tell me something, whats the EASIEST way to run wires from the engine bay to the interior. If its throught the firewall, whats the best route. I did a search and found that I should go throught the wheel well, but is that the easiest? I'm not trying to turn my car into swiss cheese by drilling, but let me know whats up. Holla.

[Ghost Beat]

easiest way in my oppinion is to drill just made sure i got the right spot by the gas and brake and drilled through got the exact size bit i needed ran the wire and sealed it from both sides just to be safe but i have read other ways some peopl have done it to me this is was the easiest havent had any problems with it

[pinoyesv6]

if you remove the kick panel and then remove the fender liner u can see that there are wiring going thru there. another place to look for is where the clutch linkage would be if u had a manual. there is a hole for that too that u can use

[Tiptronic]

you can drill your hole on the drivers side. i drilled my mine in the space where the yellow circle is. i would say about six inches down

[NRG]

It depends on what size wire you want to run.....If its 8 gauge and less, there is a hole perfect for it already drilled for you. If you remove the dead pedal you will see that hole. Thats where I wired my 8 gauge power wire....Anything bigger probably wouldn't fit......